NguyenNgocHoang NguyenThiNgocDieu DoNamSon EE332 FINALPROJECT

  • Published on
    01-Nov-2014

  • View
    105

  • Download
    3

Transcript

EE332 Design ProjectVariable Gain Amplifier with Output Stage Optimization for Audio Amplifier ApplicationsInstructor: Nguyen Trung Kien Students: Do Nam Son Nguyen Ngoc Hoang Nguyen Thi Ngoc DieuI.IntroductionThe project mainly focuses on designing an audio amplifier that can take the input from a CD player or portable music player and amplify the signal to drive a loudspeaker with variable gain. We are going to use all useful knowledge of EE 332 class to finish the acquired job. Discrete BJTs, resistors and balanced voltage source are chosen to build such a OCL (Output Capacitor Less) power amplifier with 3 different stages. The circuit is constructed on Pspice first, and then implemented on the real board. After doing the demo, we conclude that the designed circuit meets most of requirements.II.Architecture Design1. Design specifications a. Input signal specifications: Signal voltage: 100mV pkpk (min) 5.6V pkpk (max) Signal source resistance 50 Equipment available for testing: Hardware: Oscilloscope, DMM, Signal generator, power supply +/-10 V DC Software: PSPICE, HSPICE etc. b. Minimum Design Specifications of the amplifier: Output power: 0.5W (minimum) Load Impedance (speaker): 8 Unity Gain Bandwidth: 20Hz 20 kHz (-3dB) Idling power: < 1W Distortion: No audible distortion in casual listening 2. Block Diagrams3. Discussion on the chosen architecture Firstly, we review all needed knowledge of the course, find the references on the Internet and other hard copies from former students. Then we decide to choose the suitable OCL (Output Capacitor Less) architecture with 3 stages that related to the knowledge that we obtain. The circuit has to be able to amplifier current, voltage and results in an overall power amplifier. After finding appropriate architecture, we continue to study carefully all of the materials and complete the chosen architecture step by step. During the process, we usually check all the circuit components to make sure whether the designed circuit behaves as the expected way. 4. Trade offs There are a lot of discussion between members in our group during the project. Firsly is whether we should choose OTL or OCL circuit, which one is better? Secondly is the class stage, which is the most efficiency model. Protecting circuit such as Zobel is also considered carefully. Morever, we try to manipulate the capacitors to obtain desired bandwidth (2020kHz). When we build real circuit, in the first steps, we choose the transistors that dont have enough ability to suffer heat, hence the board is melted. Fortunately, we fix this problem soon and do quite well in the fixed circuit.III.Circuit Design1. Schematic2. Design equations and calculations All of the equations and calcultations are attach by the excel table below3. Simulation results: input signal amplitude 0.5V, output signal amplitude 5V, voltage gain is 10 as expected.IV. Resultsa. Bandwidth flowfhighb. Maximum Output Power - What is the largest Vpk-pk on output that is not distorted/clipping and greater than or equal to .5W while achieving -3dB bandwidth of 20Hz-20KHz? Idling power - DC power used with no input Cost/Parts Count - How many BJTs did you use? We use 11 BJTs in total, 5 for the first stage, 2 for the second stage and 4 for the third stage. - Count up total parts and submit cost20* LOG10(ABS(V(out)/V(in)))

Recommended

View more >